We get many calls for upgrades on this model, more so recently as this car is becomming even more affordable, as a guide to assist you we have created this list to save your time, guarantee your money is invested correctly and most of all give you maximum value!.

SUMMARY
Typically this car is a “Subaru’s first serious model that grew a cult following with even more grunt than the WRX”  it has good value potential and is a high performance car thats detuned !.
There are some great features of this car, 4wd, turbo 2.0 litre and most of all, a sensible budget with some well planned upgrades and it turns a great car into a STi beater!
(Editor note, this model is a very detuned option, with some carefully chosen, simple mods makes this bargain model  much better than the later model at a much lower cost)

WARNING
The Air FLow Meter sensor on this model is HORRIBLE and can cause:
+ poor performance
+ piston failure
+ Bearing failure
+ poor fuel economy
+ see below for more info
Add the common mod of changing the air intake and you have a recipe for disaster….

ENGINE KNOCK
In addition to above that is also common on the WRX, the STi has one more nasty fault, when imported originally by Subaru and sold as a brand new car, the factory ECU ran too much ignition timing for the Australian lower spec 98 ron fuel.
Originally run and designed for 100ron fuel in japan the Aussie sold car, can knock badly, resulting in catastrophic piston and main bearing failure
BUT it can be fixed!
Read on.

ECU
Can be converted and fully tuned, using EcuteK Software for almost any improvement, ECU allows solid results with correct settings and allows good improvement.
The ECU in this model is very hard to tune and is full of traps, choose your tuner carefully!

ENGINE WEAKNESS’s
Bottom end and mid range performance can be dramatically improved with ECU tune. The engine is very detunedand limited due to emisions requirements when delivered by the factory.
Poorly designed upgrades magnifies the risk of piston failure.
Run too much boost or too much ignition advance and the result will inevitably be piston failure
Boost maps, can be improved.
Car should be run on 98 Ron Fuel unless a custom (ecuteK) map is done.
The turbo is but if over boosted with boost controllers etc can result in costly turbo failures.

ENGINE SENSORS
On this model the air flow meter sensor is the MOST UNRELIABLE of all models and in 99% of cases is the root cause of most engine failures it can suffer contamination and in turn this will dramatically effect reliability and performance.
(see MRT for this solution)
The single rear exhaust O2 sensor if located incorrectly related to modified exhaust can cause problems, if old can also dull the cruise performance of the car and increase fuel use.
Crank, cam  and Knock sensors are reliable, but with age can fail.

INTERCEPTOR ECU OPTION
Not worth considering as the intercptors simply do not have enough options to tune and modify the latest technoplogy control inputs.
ZERO VALUE

ECU
Factory ECU retune is best value.
See notes above

INTERCOOLER
Factory fitted unit is “OK”, and better than the WRX, but dont fit a FRONT mount unless you plan a monster engine with resulting turbo to suit.
Use a better replacement MRT top mount, but choose carefully.

INJECTORS
Bigger injectors empty your wallet and add no power unless part of a E85 fuel retune or MRT XC power kit that includes tune, zorst turbo etc.
The factory injectors are bigger than the WRX.

FUEL PUMP
Needs to be replaced with any mods over standard specification.

EXHAUST
(Some traps for people here, unless carefully chosen.)
Single scroll turbo engine pipes with split collector to fit wastegate is necessary and will add throttle response and is good value, with the correct complete design. High flow ceramic cat in the downpipe is best.
Flex joint is needed as well, with correctly located O2 sensor.
Get this wrong and the car will suffer CEL lights,  and cause poor fuel economy.
Consult MRT for this.

AIR INTAKE
Other than a intake noise no power here.
MRT used to supply and fit Cold air intake and ram pod style intakes, but with technology and recent testing and on the later models these were made redundant. The positive intake pressure with the factory intake is best kept in place.
A replacement panel filter in the std airbox will save on future servicing but give no power improvement.
Do NOT change the air intake on this model, leave the factory airbox in place.

ENGINE ANCILLIARIES
Items such as aftermarket plug leads, high capacity discharge ignition systems etc all will ad very marginal if any improvement.
A GFB alloy pully kit will fit some models, this model has a two and three part kit available.
If fitted a kit or alloy crank pulley will result in snappy throttle response.

BOV
A replacement Blow Off Valve will add to a snappier throttle response, but give no increase in peak power. Run externally venting and the occasional CEL will occur with the downside of poor fuel economy.
The upside is adjustablity like a GFB Respons, or similar.

TURBO
If you have the budget a turbo upgrade will add power, (such as a MRT XC kit)  , but be careful the OEM IHI VF series STi turbo is best kept in place unless you have the right other parts to match a new turbo upgrade.
As the limit becomes close to the engine depending on your choice turbo and will give no value unless you plan carefully.
(meaning if you fit a bigger turbo you can use its benefits but be careful as the extra boost will need to be tuned carefully )
 

ENGINE INTERNAL
Like above if you have a solid budget, then a rebuild will give some great and huge benefits, but a rebuild will cost over $7k and then you need to choose carefully there are many options, but only if you REALLY want to.
Best value here first and foremost is 2500 cc STi short block and or new Pistons and Rods.

OTHER OPTIONS
Is the car serviced correctly? Because often a service by a workshop who really knows subarus will be your best choice for first place for power and reliability.

IE:

  • Upper engine cleaner and in tank fuel additive. (when was this last done, its a subaru suggested option).
  • Good quality low friction engine oil such as Mobil 5 w 30 will give around 5 kw and better fuel economy over a non synthetic oil.
  • Fuel system service, MRT offer this and often get good results, cleans the EGR “gunk” out of the intake and combustion area.
    Also injectors as well as inlet manf and exhaust as well as fuel pump, lines and sensors.
  • Synthetic trans and diff oil, again like engine oil this adds up in benefits.
  • Timing belt, fuel filter are again areas that should be checked and renewed.

SUSPENSION
Check out the performance / suspension section for REAL gains and benefits.
If I owned this WRX suby, I would invest first in the MRT XB kit as it will then have more power than the later 2009 model, and then some of my budget in brakes and suspension as this is guaranteed BEST VALUE!
more here https://mrtperformance.com.au/performance/suspension

FREE CHECK
Refer the MRT vehicle service section here and take advantage of our free 78 point check to ensure your car is in top shape!

PRIORITY LIST

  1. Check service history.
  2. Check the AFM sensor
  3. Check brakes
  4. ECU upgrade and re tune.
  5. New brake pads and discs if needed
  6. Front and rear sway bars.
  7. Complete (quality) exhaust.
  8. Front and rear sway bar links
  9. Positive shift kit for 6 speed models
  10. New Top Mounted Intercooler.

OTHER RESOURCES

No products in the cart.